Recent content by diytarded

Not sure how to calculate that, I'm a DIYer! Based on the distances and experience in similar properties before it would be 40-60 seconds to get hot water at the furthest points from cylinder. Are you a plumber and can you advise on my layout, any issues with it other than pipe sizes? Sounding...

Could I use 16mm MLCP which is about 12mm internal (15mm copper is about 13.6mm)? Heat pump only just getting installed, no experience using it yet but I have a very knowledgeable installer and I'll be using it with underfloor heating and upgraded rads. House will be fully internally insulated...

Hi All, I'm a DIYer attempting plumbing of my house reno. I've got a new unvented direct 300l cylinder on the ground floor - heat pump is the heat source. Kitchen is opposite side of the house to the cylinder - approx 16m of pipework away (goes to first floor and back down) Furthest proposed...