Ah I think I get you (lightbulb moment)
so if it's the same feed as the 9000 it will obviously be connected somewhere along the line so is basically a split of the same feed, which is already on the 9000 side anyway ??
The wiring for the 3 zone wiser is supposed to be as follows
So from the 9000 I can work out which of the original 3 and 4 pins are heat and water and put these to pins 1 and 2
My issue with the tp5000 is I now have 2 wires
Com and N/O
The wiser plate doesnt have anything for common
So...
That's what I assumed
My question was more to do with the other wires in the tp5000
The switched section can be extended I think
It was more what to do with the other wires, i.e power, if they are there and would be needed etc
With regard to the 2 switched live wires
One will go to the...
I am looking to wire up the existing 3 zones to the kit 3 set up
But would assume that the wiring to the tp5000 won't be long enough to reach back the hub where the current 9000 is, as much as it is almost back to back.
Hence the current wiring would need to be extended to be able reach the...
Good morning,
we have just moved into our new (to us) home recently.
At our old address we had a Nest on our old heating system which was great.
However our new system is a 3 zone, so nest was an expensive proposition.
We now have
a Danfoss system
TP9000 controlling House Heating and Water...