Recent content by don1dragon

Many thanks for that

Can anyone tell me what the building regs state as the horizontal distance between studs in a wall ?

Could well be a drainage problem you have there

Only just joined, so didn't see previous posts. It certainly is either a problem with your pressure switch or pressure switch hose. Normally I would advise to remove the hose completely and pour some very hot water down it (careful not to scald yourself) and give the tube a good bang to...

The pulley may have ridden up worm. If this is the case it will stick ad rotate whole assembly. Wind down pulley on worm and grease so it doesn't get stuck.

I assume by 'end of cycle' you mean that it's during the final spin. Check first that your load is balanced properly.

I assume there isn't anything else to bear in mind is there - just the power of the ovens ?

Try Brasso Duraglit. It may need a good scrub with it, but it should come off.

thanks for the quick reply. So to clarify, this cooker should be ok on a plug top ?

I have a Collins DIY book which states that any elec cooker under 3kw can go on a plug top. We are looking to buy a dual fuel cooker. Main elec oven 1.7kw Top oven 1.3kw Gas hobs. This totals 3kw. However, the manufacturers state that a cooker connection at 30A is required. Any ideas ?