I can't really tell where its coming from, but it can be heard through the pipework. It also continues to happen once the boiler has switched off and the pump is still running.
I tested yesterday by doing the following
1. Switch on CH - no noises
2. Switch on HW - no noises
3. Switch off...
They are obscure windows and dont open. We also have them down our side and dont really provide much light. Ours is a small window the kitchen roughly at worktop height so assume that the neighbours will be the same, though they have 2 and the one at the front goes into the front room.
Hi just found after posting something very similar and only started happening when pump head was changed and isolation values were turned off. Though one of them didn't seem to turn off even though fully turned
After changed pump head they were turned back on, could one of the isolation valves...
thanks for reply. the cylinder stat is on 50. the water is only heated twice a day, so at both times is when HW starts is usually only warm and rattle starts straightway.
Its almost like something is moving around, piece of debris or something and can be heard from 2 of the radiators at the...
immersion is off and the water in the cylinder is near enough cold. though good point it might have initially started when the immersion was on, water was boiling and the boiler has heating the water.
Could something have broken and why doesnt it do it when the HW and CH are both on
hi, we live in a semi with a detached house to the right. We have our own driveway in between both houses which goes all the way to the back and the garage starts where the garden starts.
We are thinking of a rear extension which will be the whole width of the garden but also wondering how...
firstly great forum here and lots of great advice.
I have a problem that has started a week ago. When the HW is heating only, i can here a rattle somewhere around the cylinder. it sounds like its coming from inside but not sure. However when the CH and HW are on its all quiet. What could...