Recent content by Dpvi

Hello, thank you all and John, you were almost right, I cleaned the MAF sensor today with a £5 MAF cleaner, but noticed as I disconnected it that one of the pipes was a bit loose on the MAF sensor, made sure both pipes were tight after, and so far everything is back to normal, even better I...

And another thing, with maf sensor connected when I put first contact the engine does a cracking sound. Without the maf sensor connected, at first contact the sound dissapears. Thank you- I am a novice with mechanics but I am giving it a go.

Checked pipes, no sound as far as I can hear. Question: I have disconnected the maf sensor , as suggested on some forums, start the engine and cuts out after 2 seconds. Is that normal? Thank you

Another thing, the spanner comes on when I start it cold and switch off/ switch on the engine and doesn't come back. When I had it tested I have been told no errors. So usually in have the spanner on in my first 10 minutes in the morning , and after restart it doesn't come back until in the...

Thank you for replies. I have noticed that since I have changed the crankshaft sensor the car starts to stall quicker, the engine it's not even warm and starts to stall. Would this be any help for anyone? Could I went wrong with the crankshaft sensor? Would the car still run if I made a mistake...

Thank you for reply. Rev is fine, fuel filter and air filter were changed recently.

Hello. I have some problems with my corsa which I am trying to solve. First, at cold start it takes a few key turns and smokes a lot when starts, I have changed the glow plugs and problem was fixed. Second, it drives fine until the engine warms up, when it starts to stall in lower gears and...