Recent content by dr_bogenbroom

Thanks both - we’ve decided just to make the investment in new windows. Will do the worst offending windows now then the others over the next couple of years

There are 2 hinges positioned at either side. The gap is in the middle to bottom half at each side. I took a straight edge and it does appear to be bowed slightly.

Windows are 30 years old and they need replaced but was hoping to drag them out for longer. The windows closed really tight but some parts still have gaps when doing the card test. My only thinking is that the frames are warped and beyond repair?

Boiler is downstairs in the garage

So you’re saying this has been set up wrong?

Oh and to add it’s an oil fired heating system not gas.

In the last picture the cold feed is the 15mm pipe to the left of the new air valve - it connects to the coil feed at the bottom of the cylinder. The air valve and zone valve is connected to the coil feed coming out in the middle.

Ok will get today - when you say cold feed do you mean the feed to the CH system via the F&E tank?

I had a power flush and some zones added to my gravity fed CH system - I later discovered they had disconnected the vent pipe and added the below valve, any idea why? I’ve had to bleed the radiators a few times since they left. I also need to replace a faulty TRV and was planning to just bung...

Access is a pain but can be done with ladders - I’m not sure if it’s worth replacing the whole sill with concrete or uPVC or repairing it - if it was repairable what would be the best way? You can’t see it in the photo but where it broke off there is a piece of rusted rebar.

I’m re-routing my mains input and stop cock soon and want to know should I renew the existing fitting that’s connecting the MDPE to the copper pipe or replace that as well? It’s not leaking and is about 30 years old. Not sure it’s worth it, and I should just cut the copper pipe and solder in a...

Well I never… what an age we live in! Never knew this existing, looks perfect!

Hi, I've attached a diagram of my current set up along with photos. I want to move my stop cock to under my utility room sink - it currently sits behind my washing machine which is difficult for me to move and impossible for my wife, should we need to isolate the supply in an emergency. It...

For a minute there I though this was a tartan paint moment - much appreciated thank you

Expanding foam? And what should I seal it with?