Recent content by dstill

I’m assuming as I have a 15mm supply to my existing garden tap the 20mm MDPE pipe will be the best size to use? Thanks in advance.

Thanks, I thought if the pipes were insulated this would stop them freezing as that is basically what the vertical Insuduct does?

Yer, not sure what depth though, if I insulate the pipe I’m guessing I don’t need to go down to 750mm?

I’m looking to replace my outside tap with two outlets so I can run a pipe into my detached garage. What would be the best way to do this? I’m intention is running the pipe down from the existing tap underground then vertically up my garage wall and using an insuduct as below.

Thanks guys, appreciate you all taking the time to help, will try these ideas, thanks again.

To be honest the profile of the tailgate would mean a huge loop of cable would be visible if I put it on the glass.

Yer, it was the VHB type.

Can anyone recommend a strong double sided tape to stick my rear dashcam to the plastic trim please? I’ve tried 3M, Gorilla clear double side tape, standard foam double side pads and nothing last more than a few days.

So, just after a bit more advice before I push the purchase button please. Honeywell is now not an option for me so that just leaves me with Tado which I'm comfortable with. Tado Technical Services have advised to fit two of the Tado X Wireless starter kits but that raises a couple of...

As you know I was considering the Honeywell T6 range, according to their technical department using T6 room thermostats , one for each zone is not possible with my 2 zone system, response from them below. Hi, Unfortunately no, you cannot link 2 thermostats T6 with the same recover. Each...

.......well, its been nearly 4 months since I posted this and the Xmas holidays have been the only chance for me to get some time to progress, shocking I know!!! I've narrowed down my options to the Honeywell T6R. The cables are already there from the old thermostat but I've had to go with...

Hi, thanks for your reply, I'm just wanting to have a two smart room thermostats, one in each zone.

Hi, just looking for some guidance on the following please. I've decided to upgrade my standard heating controls to a smart system. My heating system is 2 zone with two room programmers, one on the ground and one on the first floor. The ground floor one also controls the domestic hot water. I...

Thank you, I'll bare that in mind, never thought about doing it that way.

Hi, I'm new to modellers air brushing and trying to get to grips with suitable paints and mixing ratios. I generally use the air brush for painting plastic model cars. I've used a couple of different manufacturers of water based acrylic paints that I've tried mixing with either water or Humbrol...