Recent content by Eddytor

Update: There was many issue and i cost me so much money :cry: I struggled a bit to find a technician as all of them were very busy. I ended up finding one though some contact They guys found a fault between the receiver and the boiler itself, apparnelty they were not compatible and that...

so, I just bleed 2 radiator to see what would happen, only (gross) water came out, at a constant flow, there was no air. I managed to reduce the pressure to around 2.5 bars, but unfortunately it made no difference. I also made sure to turn some of the position on the theromstats to "off" and...

Yeah I did set it up as "always on" to make sure this was not the issue, i've tried changing it again, but since the receiver is picking up on the demand, I dont believe the issue is with the thermostat itself Yeah, it disaply "d" I beleive, or whatver letter correspond to "hot water demand"...

I tried to leave all tap running hot water for a couple minutes but the rpessure did not really go down at all. I'm not sure a pressure too high would cause the heating to not working at all though, no? Do you mean the button on the very right ? So you beleive that the button hitself would...

I tried pressing the small black button on the receiver, the light tunred off for about a minutes, then cam bakc to the same situation. I tried using the "reset" feature on the boiler itself, but no difference The pressure is about 3 bars, with a maximum of 4 As I said, I genuinely beleive...

Yes, i made a point of leaving the theromstat just next to the boiler to make sure nothing is blocking. On the manual it also says that "(make sure you are not holding the room thermostat as this can interfere with the communication link to the receiver)" but it does not seesm to make a difference

Are you sure ? Because when i set the temperature to 30°, the light remain red, and when i set the temperature to 20° or lower, the light is off, with 2 blinks every few s econds, This seems to match the decription of the guide: When the room thermostat is on and the room temperature is less...

Thank you everyone for your replies. Log story short, the theromstsats and the boiler now seem connected but I still dont have heating I have tried putting brand new batteries, then pressing the reset button, then seeting the tempreature to the lowest setting, then setting the temperature to...

Thank you for your reply. I don't beleive the link provided match the thermostat I have Comparing the pictures I provided and the one if the PDF, it seems to be different devices. There is a small black button on both the thermostat and the boiler ( i beleive to reset them) and I tried pressing...

Hello. I bought a flat a few month ago, but I cannot figure out how to get heating. I have gaz, and the Combi boiler (Ideal logic combi 30) is working for hot water, but not for heating. The boiler always display "0" which apparenlty means that there is no current demand. I set up the remote...