Recent content by egral

Best thing to do is go on google and type in mortar calculator, and you will have you answer its brill in fact if you want and quantities for building just type ----------- calculator to get the one you need . Paint bricks sand cement mortar tiles get my drift. hope this helps good luck

Question- what room is it in has the room got any unevenness You could install a floating floor, this would be visquine membrane (polythene) 1 inch polystyrene then chip board flooring over the top gives you toasted feet. estimated cost for this per square meter for materials would be...

Cheapest and safest way to repair is to buy a tube af sticks like **** this is trade name, get a 6 inch piece of roofing felt or DPC stick over the hole from outside, job done DPC will last nearly for ever and sticks like **** will adhere to virtually anything cost for the lot 5.00 quid...

a picture would be good in this case, however if your door shut before it could be loose on the top hinge, check the tightness of the screws in this area first, if its loose you may need to remove a couple of the screws and replace with slightly longer or a thicker gauge if the hinge will...

All is ok in the external boiler housing, plus the pump does sometimes do what its told too, is this clock related or valve related maybe and if so which and how do i know ?

Wall star balanced flue oil type never had any issues for 10 years its got two danfoss valves vented i think the boiler does shut down as well sorry about the lack of info but thats why i am asking guys i need help please.

This could be quite simply a few questions is this a new house or old . Moving forward if you have had a long term leak the joists will have been saturated with water,this will make them swell considerably in size, so you then renewed the floor boarding onto wet joists and placed the bath back...

pump refuses to turn off after CH/HW as finished runs forever until i switch off the isolator this happens 80% of the time. Any ideas please

pump refuses to turn off after CH/HW has finished, runs forever this happens about 80% of the time.any suggestions welcome than you