Recent content by electroheat

I believe I found the two ends to connect the loop to, unfortunately not the loop itself. One quick question: will I need to pump the air as well or only water to reach 1bar? thanks for your help in any case

One quick Update: the pressure vessel dial shows no pressure. However, contrary to some sites I found on the matter in this one the air vent is located at the bottom. It will probably be easy enough to pump air to 1bar with a bycicle pump but wanted to double check that's the right thing to...

Hi all, I replaced a dead Myson CP53 pump on a pressurised Amptec water+heating system. That was easy enough but after restarting the system I found that there is no water at all going through the pump (I did open to valves surrounding it). Another problem is that the new pump makes one major...