Recent content by EllieP

I've managed to lift it a couple of inches, sitting on waterproof boards and sloping down towards the outlet cables. Feed cable entry id via a sealed gland, and I've added further selant all around the box. Wiring back to the garage is unfortunately not an option now due to some very expensive...

How do you access it to plug things in? One of the short decking planks is easily removable, and once it's all up and running there's little need to go back to the socket. I'll also silicone seal the lid etc (not that I'm paranoid!) There's no standing water (OK, maybe a little) but I should...

Perfect - thanks jj4091. We've got some leftover composite decking so I'll try to get a couple of layers under the box.

Thank you Harry. I don't think there's enough clearance under the decking to mount it upright... Would lying the box on its back on timber or something be OK?

Morning all, We recently had new decking laid, and as part of the process an electrician (supplied by the landscapers) wired us a weatherproof socket under the decking to take the water feature and decking lights (both on low voltage transformers, IP44 I think...) My concern is the pacement of...

Hi all, I think I might have made a huge error, cos I have put a JG push-fit elbow in a stud wall (is that the same crime as using compressions in a solid wall?) Second issue is that I had planned to used chrome-plated copper tails to the towel rad (copper tails are already in place but...

Not any more I'm not! :cry:

I asked for drivers specifically for these lamps... Was thinking I could hopefully double-up (i.e. two LEDs per driver) as the drivers are a tenner each, but I was told that each LED needed it's own eaglerise thingy. With regard to constant current/constant volts, its probably me getting my...

Thank you Mr Flameport, We don't like a timed overrun on the fan - whole idea is that it goes off with the lights plus we can switch the fan off from the FCU on bad-hangover-days (on morning-after-curry-nights we just leave the lights on a few minutes longer if necessary!) Small LED boxes...

Thanks Bernard, Know what you mean about things being built to give up, will have to wait and see.....

This is the planned circuit taking into account new extractor (same location, just updating fan unit) and the 8 x LEDs. It was all previously wired through the existing FC, but there are just too many wires to stuff back in the box! (Being a stud wall with a plastic back box if I push the...

Thanks! Will do... I'll make sure the drivers are above the loft insulation, just in case they do tend to run a tad warm.... Good thinking Batman! FAILS! Why would this be? Pure and simple old age and over-use or could there be a more scary reason? :shock:

Piccie here... http://www.thelightingsuperstore.co.uk/product.asp?productid=42612 Driver is approx 30mm x 25mm. Each pair of cables is approx. 500mm long.

:evil: Hmmph! OK - we'll try again... "Greetings to all you wonderful, clever, intelligent, highly skilled and prfessional electricians," NOW can I have an answer or two? Please?

But of course, how remiss of me.... Let me re-phrase.... "Greetings my little and tall Sparky-type peeps,"