Recent content by EMFTeo

  1. E

    Hi there, Have you managed to configure your Visionic PowerMax express SMS settings? to send...

    Hi there, Have you managed to configure your Visionic PowerMax express SMS settings? to send SMS if the alarm is triggered? I've no luck.. perhaps you can share your experience pls? Thanks
    • EMFTeo
    • Profile post
  2. E

    Help needed with Visonic powermax express GSM setup.

    Hi there, Can't seem to get it working too... tested the SIM card in the GSM module and was able to dial into it.. so signal strength isn't an issue. When you input the SMS number, do you enter 004479123818 or 079123818 ? Thanks
  3. E

    Help needed with Visonic powermax express GSM setup.

    Hi there, Can't seem to get it working too... tested the SIM card in the GSM module and was able to dial into it.. so signal strength isn't an issue. When you input the SMS number, do you enter 004479123818 or 079123818 ? Thanks
  4. E

    HETAS Engineers a bunch of lying so and so's....

    Hi there, We too are looking to get a wood burner installed... been quoted the following: Remove current fireplace suit Reform opening Re Lintel and widen opening Chimney sweep Supply and fit a fire chamber (black) Lay Hearth and Back Hearth Any plastering and making good Supply and...
  5. E

    High end Combi vs. Unvented for 3-bed semi-D & 1 bath.

    I understand that it's CH which needs to be taken into account then.. our requirements are no more than 15kW for CH and a minimum flow-rate requirement of 13++ lpm ? Is there any combi which can supply that? Would fitting a multi-fuel/wood burner stove (8kw) in the living room and...
  6. E

    High end Combi vs. Unvented for 3-bed semi-D & 1 bath.

    Spoke to my plumber again, and he said they were of no match to the 837 on flow rate ?
  7. E

    Vitodens 222-F

    Just had a look at this model. Am I right to say its an unvented system which is all built in 1 unit? Would anyone know how much that would cost?
  8. E

    High end Combi vs. Unvented for 3-bed semi-D & 1 bath.

    The rated output is 4.8 to 36? That's pretty high? I assume it can be set to the minimum? If the house is well insulated and heated ? Is this the same for the intergas? Out existing boiler is upto 15 kw. I guess that's all we require.
  9. E

    Intergas Combi Compact HRE 36/30 owners out there?

    Reply sent as well... 8)
  10. E

    Intergas Combi Compact HRE 36/30 owners out there?

    I've messaged him and emailed him too.. no reply..
  11. E

    Intergas Combi Compact HRE 36/30 owners out there?

    The job is still open.. LPG certified Gas safe in Berkshire... Conversation seems to be all talk and no volunteers.. and they say we're in a recession...
  12. E

    Intergas Combi Compact HRE 36/30 owners out there?

    Yes I think the 36/30 will be sufficient (we have 1 bath/shower). Our budget is limited to a combi. We run on LPG and we want to minimise LPG consumption costs. How different is that vs. the 837 ecotec plus for CH ? We just need a boiler size for 12-14kw. Thanks
  13. E

    Intergas Combi Compact HRE 36/30 owners out there?

    Job is still open if anyone wants to install a LPG boiler in Berkshire...
  14. E

    Intergas Combi Compact HRE 36/30 owners out there?

    Pls. look at: //www.diynot.com/forums/plumbing/high-end-combi-vs-unvented-for-3-bed-semi-d-1-bath.308347/page-3 The heating engineer has recommended the Vaillant 837 EcoTecPlus (LPG). Our water pressure was measured as: 5 Bar pressure and 24 litres/min flow rate
  15. E

    Intergas Combi Compact HRE 36/30 owners out there?

    I've just looked at his company's website and emailed to him directly. Nearest town is Maidenhead.
See more
Back
Top