Recent content by esf666

So i finally sorted it, turns out my channels were back to front! Thanks all

So is the stat the only thing that actually calls for heat and then only if a trv is turned up?

Thanks, i will be trying your suggestions. Just as i was typing this, sitting on the loo (tmi) i tried turning on the loo rad and suddenly it chose to work. Maybe I'm just using the whole system incorrectly. Will get photos of as much wiring as i can. I think my biggest issue is...

Which plates? I have changed wiring on 2 wall stats and a control unit. Also was working other day until i replaced 2 non trv valves with trv's

The boiler is firing and making all the right noises. All photos are in this thread

Anybody?

So my wiser says heating on, boiler and cylinder both make the right noise but no heat is being received in any of the rads. All of them have wiser trvs on and I've tried every setting on them. The system even comes on when i try adjusting the trv, but no heat. Tried bleeding the rads and...

Yes

Downstairs stat

Have tried to put the downstairs zone on and am getting absolutely no heat :( Swapped the wiring as per the upstairs stat

This may be a(nother) daft question, but do we actually need the room stats . Theoretically couldn't we just either leave the heating full on and control everything thru trvs or just use the trvs to call the heat

actually update, it does seem to turn on eventually, but only after i hit boost and then it doesn't turn off! :(

no, not calling for heat :(

okey dokey , inside of my room thermostat, and that extra controller on cylinder

No they couldn't