I tried the strobe and bell on op2. Only the strobe flashes. The bell doesn't work. For now I've connected the indoor siren and outdoor strobe to op2. Alteast I will have some sort of notification when an alarm goes off. I suspect you are correct that the siren is also faulty. I will fully test...
I connected internal siren as instructed. All I got was a shhhhhhh sound. Voltage read as 1.5v when testing. Could it be a faulty panel somehow? I’m hoping it’s not as it’s going to be a hassle taking it out. Is it worth while getting a professional in to fix it?
No join. Same wire. Someone else got on a ladder and did the other end of the wiring so i just matched it up on the panel end to the appropriate points.
I have an internal Honeywell SP20ST sounder https://www.security.honeywell.com/uk/products/intruder/alarm-communications/sounders/524172.html...
Also using a multi meter, I get 11v on OP1, 13v on OP2 and OP3. I should also note that the sensors also give out 13v. Strangely I get only 3v at the other end of the internal sounder wiring and 4v when i set this to test. I can't get up to the bell box on the wall outside to test that end but I...
Tried it and it doesn't sound it. Tried connecting bell directly and it works when i connect it directly to 0v and 12v. But doesnt via op1. So confused. Why do alarms have to be so complicated?
My external bell box which is a Honeywell ag6 does not work either. All it has is a red light illuminated on it.
This is how I wired it. 929B2C8E-1B29-40D0-A43B-9CF6C8663E0B by eshaq786 posted 29 Apr 2018 at 9:13 PM
Tamper to T
ST to OP2
S to OP1
V+ to 12v on sensors
V- to 0v.
Do I need to...