Recent content by fatcontroller

The set up stated above using isolator switch is easiest option but can't see it being to difficult to feed a new cable down, and the connections, at switch, of the new cable would be what?

Many thanks, the point you made about only neutral coming from permanent live being surprising but plausible, is that still safe?

Only using one speed and fan to run when light switch turned on, correct. To clarify, I should connect the earth from rose to the earth in switch cable and use neutral and earth from 3 core permanent live cable alongside the switch live from the rose, isolating permanent live in isolator switch...

Found this on another thread, looks like the same sort of question as mine, 'SAFELY TERMINATING LIVE OUT OF THE WAY' does that mean the entire cable or just the Live? If only the live is terminated, do I then connect only the switch live and leave the unsheathed core disconnected and still use...

The live from rose is red and other core is unsheathed and being used as earth, the fan runs non stop when connected to the three core from switch.

I assume you mean the 3 core cable, if so, red, blue, earth

Manufacturer says to fit fuse switch

Good morning all, I am new here and need your help and advice. I am changing a fan in en-suite from a timer unit to a two speed inline non timer unit, I also have to connect through a new fused 3A switch unit. I have confirmed which cable does what but I have hit a snag as regards the switch...