Recent content by fattony

Thanks, appreciate your time to reply

Hi I had BC out today to inspect a 2 story extension we've had built, builder did the shell and we did the internal ourselves, hes noted 3 items which we need to address, 2 of which I'm curious about. We have smoke detectors in the garage (attached), utility room, landing, new bedroom and...

Hi We’ve had a small leak from the shower and I’m trying to work out the extent of the repair required. It appears the corner bead is rusty, so does this need removing or can it be repaired at all? Thanks

Thanks, it doesn’t have a closer, building control may request it does. I was wondering about fire foam but wasn’t sure if it would be accepted. I’ll have a look at the mineral wool route first. Thanks

Hi I have a fire door fitted between an attached garage and utility room, it’s plastered on the utility room side but not the garage and I suspect building control will want something in the gaps. Any idea what I can use, hinge side there is room for fire board but it’s only 50mm, there’s a...

Would it be worth adding a supporting timber the width of the step on the underside? couple more photos

Hi I’ve had a look at the stairs and looking for more advice. from the underside the issue seems to be movement between the step and riser, someone has previously attempted to glue and screw but it’s failed, I’ve been able to tap a wedge between the two. I’ve attached a photo, does anyone...

Thanks, I’ll order some timber wedges from Amazon and get them in first, apply some glue and then fit some blocks to brace it

Hi I’m attempting to fix the squeaky stair issue from underneath the stairs, the house was built in the 80’s and over the last couple of years they have got worse. I’ve seen a could of bits online but wondered what’s the best way, I was thinking glue round the joins and screw a 2x2 to the...

Hi for a 610mm door what would the internal dimension of the door lining need to be, looking at a 762mm lining it measures 770mm so I’m assuming it needs to be 618mm but want to double check thanks

Ok thanks, I’ll cut an inspection hole and find a structural engineer thanks

Hi not sure if this would be better in the carpentry forum or not... I purchased my house with and extension already built in 2008, I want to remove the ceiling a vault it which would mean cutting away the ceiling joists. Would I need a roofer to look at it to determine if additional supports...

Hi I’ve been trying to balance my radiators and after the hearings been on for a 10 mins and settled most of the radiators are reaching around 50 degrees while 3 are just 26 degrees. question is do I restrict some of the ones reaching 50 degrees on the lock shield or open it to allow the water...

Mmm, yes reading into it I believe the soak away must by 5m from the house. fitting an Aco and running a drain off down the side of the house isn’t the worst idea to be honest, but if work but doable thanks

Hi I have a detached house and the drive slopes down towards the garage with no drainage in front of the garage, the water runs down the drive into the path to the side of the garage. so I want to put a Aco drain in front of the garage but not sure where I can run the water to, there isn’t any...