Hi,
I put a continuity tester across terminals 1 & 3 on the digistat 3. Is it normal that I get a signal even though the thermostat is set to low?
Using the multimeter, how would I test further?
cheers
I'm very confused - not hard I suppose :D
I'm replacing a Danfoss RMT 230 with a Digistat 3.
The Danfoss had 3 wires connected:
1) Red to contact 1
2) Yellow to contact 2
3) Blue to 4
According to Danfoss, contact 1 is Live, 2 is Call and 4 is N (common?)
When I connect the...