Recent content by FirstTimeDIY

Obviously I will rectify the downpipe issue at the same time

Thanks, in that case would filling the cracks between the concrete slab to the front of the house and the house itself help?

Noticed some damp in the corner of our living room, and the culprit seems to be some blown render on the exterior wall of the house, as this is directly outside where the damp is: There are two steps up in to the house so floor level inside the house is 300mm above the exterior ground in the...

Thanks all

Am I correct that there is no 22mm vs 22.2mm discs, and all 230mm grinder discs should have the same bore?

I know how to fit the disc properly, so either both my and my friend's grinder's are duff, or its the disc...

Its an Abracs "General Purpose Diamond Blade 230 x 22mm" that I bought from Toolstation

It's a Hikoki G23ST. I also tried the same disc on a friend's Titan TTB879GRD and had the same issue

For context, this is a new corded 230mm grinder and disc I've just bought, as my 20V Parkside cordless 115mm grinder wasn't quite up to cutting some concrete paving slabs. I've just tried all the discs I have for my 115mm grinder (which have the same 22mm bore) and they all fit over the arbor on...

Its not an easy problem to take a photo of - I've had to take the washer off the grinder to try and demonstrate - the fit between the arbor on the inner nut (washer?) and the bore on the disc itself is so snug it won't fully go over it and sit flat The cutting disc I bought was sold as...

It isn't the outer nut that's the issue, its the inner one, which has an arbor the disc bore is supposed to fit over

Yes I have the nut the right way round, flat face against the disc

Obviously I'm not using it when it wobbles! I stopped immediately! I'm trying to find out if I've bought the wrong disc or if the disc bore is slightly out of tolerance and too small

Do angle grinders in the UK have different arbor sizes? I assumed it would be standard, but some grinder discs are sold as 22mm bore, others 22.2mm. I recently purchased a 230mm diamond cutting disc, I have tried it on two different 230mm grinders (Titan and Hikoki) and it will not fit over the...

Yes that's for everything, haven't got any quotes yet but SE said off the top of his head it would probably about £1k, if not slightly less, for the job