Recent content by flashbanger13

Can you experienced sparks recommend a decent, hardwearing multimeter for around 40 - 60 squid. doesn't have to be too fancy. Thanks for taking time to reply.

If it must go on that wall with the bracket, and you don't want to come home with whats left of your TV on the floor, drastic action must be taken. IMHO. I would chop out a section of the wall the width of the bracket from floor to ceiling. Then rebuild with studwork, plasterboard etc...

Oops, wrong thread.

So, are you guys says it would be acceptible practice to...for example. If running a 2.5mm radial, 16A MCBsupplying socket outlets. If the cable at some point went through some thermal insulation, you could increase it to 4mm just through the affected part of the run, returning to 2.5mm when...

Hi Roofers, Can someone give me a ball park figure for a re-foor on a 3 bed semi. It is currently the original roof from the 1930's (i think) consisting of rosemary tiles with no felt. THe ridges have started leaking. It is in the South Wales area if that helps. I understand it will...

130-07-01 states 'No addition or alteration shall be made to the existing installation unless... the earthing and bonding arrangements are also adequate.' This regulation does not cover the school of thought that if, for example nothing has been touched in the bathroom, it is "in no worse...

Hi all, Can some of the more experienced please confirm these points as correct or not! If method of protection against indirect contact is eebads, main bonding must be upgraded to 10mm2 before any work is carried out on an installation? supplemetary bonding need not be...

It enters through a wall directly from a radiator on the opposite side which is in a dining room. There are two circuits and a shower which i can get to under the floor above, but this towel radiator is posing a tester.

Hi all. I've got a towel radiator in a downstairs bathroom. It is T'd off a radiator in the dining room which is directly on the other side of a one skin wall. I've got nowhere to hide the clamps! Any tips please?

How many terminals are there in that JB?!

Your best bet is to go to a couple of electrical wholesalers and ask there advice on fire alarm products. Probably not going for the cheapest one is wise.

As stated in your replicated screwfix thread, the PFC is measured in amps. Therefore its 0.930KA.

Read BS 5839.

Many thanks Spark123.

Cheers Adam, Have you used them? Can you recommend the Pin in or Pin out types? :?: