Recent content by Flashbaztard

I will answer my own question No it should not be on full blast It sounds to me like its a fault with the modulator (since you have checked the thermistors) Better find out what voltage is going through I think! No offence meant ! But I think im winning now! Thank you again to all that...

Difference between tight and skint! Guess you never knew what its like to have no money. Lucky you!. Was a time I would have made the same crass comment,when running my own garage,in me ivory tower. But when the missus leaves you to bring up a baby on your own things dont go so well But I just...

Engineer is out of question im afraid couldnt afford call out! Only reason got another combi is so that it would just be a connect up and use (well that was the theory!) Simple adjustment but cant tell me?? Well ive stripped 75% of it down already so I guess I will find it in the end (Only...

Swapped heat plate with my old one (had no problems in old boiler)but no difference !swapped all sensors (3 of them) and still the same! Temp goes right up and thermo cutout shut boiler down Its as if there is not a fast enough water flow over the burners. But according to the neons all is well...

Thank you for your help Ill work down the list Heat exchanger first Thanks again!

Changed pcb because some forums put the blame there! And I took it out the old boiler witch im keeping for spares!!

Sorry mate but im skint. And with any new boiler. Starting at £500. I had no choice! I run a animal rescue and never have more than £50 in the bank at any time! ,there are poor people in the world you know ! It was advertised as in good working order!

Thanks System was all connected to house full of rads but we never used them! Over time some of the rads were moved ect so I capped pipes nr the boiler temporarily . that was many years ago. And never got round to putting it all back may do soon!

Connected but only a foot of pipe each side then blanked off (old system ran ok like this) Pressurized to 1 bar

Hot water runs as the water gets hotter it then cuts out the burner. If leave tap running it will cool down and burner will start again for a bit then cut out. And keep going like this!

Hi Just fitted a second hand 105e boiler to replace my knackered one I only use this for hot water only! But it runs when you put the tap on but then the temp gauge lights go up to 60 and it stops heating.then after a while it will heat again! It is like its running the heating system and not...