Recent content by flibodob

hi guys I need to get some radiators, unfortunately the ones that were in had been taken out before I got possession and I have no sizes of the old ones the the width between the valves coming from the floor are 980mm or sizes closed to. my question is, if I buy 900mm wide will that be...

hopefully someone can help with this, i've been planning a kitchen using ikeas tool. i have a range that i want at the end of a new counter / cupboards but the tool says i shouldn't put drawers next to an oven or range but it says a cupboard is fine. any idea why ? or should i be able to do this...

thanks for the replies guys it is an excel 80, just when i moved in i found out it was leaking, got a plumber out to look and the air vent has gone. plumber made a temporary repair ( could have sworn he put a car tyre air cap on the vent and some tape) to change that, would cost as it would...

i need to change a vokera 80 boiler. housed in a bathroom within a cupboard there's 6 radiators in my house and i would really like something with better hot water flow 14l + the plumbers i have spoken with have said an ideal, baxi or even another vokera but reading on here i kind of get the...

ok, i have set it to roughly 9.5l its maybe a little on the low side. the water still only seems to get proper hot after a movement of the tap or with the tap not open very much. the 22mm flow pipe i'll have to check tomorrow as the missus had the heating on already. thanks for the help guys

when i turn on a hot water tap, the water only gets propperly hot when i have adjusted the tap. like when i open the tap and close it until the water starts getting hot. i have no problems at all with central heating and rads both upstairs and downstairs heat up fine. i have tried...