Recent content by fox1980

Thanks Woody. The final colour is not decided yet, I was going to use vent trim along all edges of the battens to provide the air gap and cut the cladding short around the top edges, should be covered by the barge boards. I may go with a simpler horizontal tongue and grove, I was playing with a...

Would it be a chicken wire set up with render applied to it? You can only see black bitumen type paper internally and a lead flashing at the bottom edge although not visible externally.

Hi all I am planning on removing this timber and render panel cladding and replacing with oak in a herringbone pattern. Does anyone know what to expect when removing this? How would it be fixed, in the loft there are vertical timbers in line with the external timbers, then there is a black...

Hi all, Could somebody assist me with how to register TCC800M fobs with my Galaxy Flex 20 panel please. I have the RF module installed. Thanks

Can I clarify something regards connecting a dialler to the output module, I have 3 inputs on the dialler and I want to connect 3 triggers programmed intruder, pa and tamper. Is this possible and do i need to connect a resistor in series with the triggers.

Must have been something like that nothing else to explain it. Many thanks for investigating for me.

Hi yes wiring was connected as you say, when I first enabled the module the led did not illuminate. I reconnected the module and enabled again and now it works. Bit confused at what the issue was as the connections where as the instructions. Thanks for taking the time to look into this. Is...

Thanks for you help much appreciated

Im not by the panel but its a v3.37 if that helps

Hi i have removed the module and connected the outputs direct to the panel and all works ok. I used the lead with the module connected red to 12v, black to 0v, and yellow and green to panel outputs 1 and 2. Then the bell and strobe to trigger module output 1 and 2 respectively. Sorry didnt take...

I have also checked there is 14v present at the trigger module input but the led in the centre of the pcb is not active.

Are the jumpers on the trigger module something maybe?

Hi as instructed I have connected the bell wire direct to 0v and it sounds. The trigger module is enabled but under test in the panel nothing happens for bell or strobe

Ok I will try tomorrow thanks for your help I will let you know the outcome

Neither strobe or siren and the output polarity is set to neg as per siren manual