Recent content by Fud

Hi chaps, I'm in the early stages of planning an orangery and am very keen to get hold of any drawings/plans that I can use as inspiration for my design. Any info would be v greatly appreciated!!

Yeah have heard that (subsequent to buying of course) but not sure whether that requirement will be in force over here (Channel Islands) although I guess it is. I'll tweak the pressure and see what that does, if it's no good I'll change out for a type 2 but perhaps I'll just do that anyway...

OK I'll give that a go. Should the part 2 valve cure the problem anyway or is there a chance it could happen even if I swap them straight away?

OK sounds likely, especially as it seems to be getting better already. Any tips re the new ball valve? Surely a new part should not be so bl00dy noisy??

Er don't think so. Have an oil fired boiler for central heating and hot water for winter and an immersion heater in the hot water cylinder for the summer, if that makes sense?

Just installed new cold water storage tank in the loft, including new (Part 1 High Pressure) Ball Valve, which is now making an absolute racket. Old one was fine, but not pretty to look at... B&Q part installed, anything I can do/have done wrong?? Feed is straight from mains. In addition my...