Recent content by G1zm0

thanks guys , I thought that . the boiler is old and the pipes are 10mm , and rads are old. I want to renew pipes but lifting floor isnt option since most is tiled and other has 2 subfloors and laminate layer down . only way under is to crawl from hall under house . but dont think installer...

in 2022 with the cold weather my pipes burst. the pipes entering the boiler iced up and froze, when it thawed the ice had caused the 2 pipes to pop out . the boiler was full of water , I had to take cover off it to drain it . the boiler has never been used since . its a glowworm fuelsaver 3 ...

forgot side view

the damage to car is the inner trackrod , tierod ,and the strut was bashed in. wishbone , deiveshaft,hub look on , wheel arch liner is intact aswell . , when I looked at killer, its OK, lines around door are good , door opens and closes apart from catching .

hi , I bought a cat n car , car was hit on wheel , but part of the damage is hit the door as seen in pictures. the door clips wing as wing has been pushed forward. before I spend money on a new door , can this one be repaired .

thanks that was what I was looking for , few leccy places I tried said it didn't exist lol , yess and b&q

the old outside light that was a circle has died , its going to be replaced with a pir floodlight , the light has a Small cable entrance that has a shroud and gromit. the old light the t&e went into its rear casing , the new one is about 5 inches from wall. to run this cable to the new fixing...

that's what I was going to do , , my bathroom is tiled all over , I done the full bathroom remodel , but can't remember if ceiling is just in that room ,so when I rip it down it doesn't bring down part of celing in other adjacent rooms. also need to find best way to snake a cable through...

I will mark it out and cut along the damaged bits , dreading covering up the artex bits that will be left on bit I don't take down . bathroom is 3x2 m

it has the bulge bit , and a hole, piece that broke off when trying to push it up was dark gray , so took on water , think 80% celing is like this

I had a leak from loft watertank . it was dripping from ceiling onto floor In hall and possibly running down inside a wall (covin Is stained, but wall feels dry). the bathroom celing was bulging, so I screwdrivered it to release the water, and threw out all wet stuff in loft I need to...

heat up rads quicker, with 8mm just now it takes hrs to Heat. so higher flow , quicker warming rads

lol autocorrect , should be vented (old style system)

hey , I'm looking for what a good price would be to renew my central heating system . its a unvented system with tank in loft and cylinder next to boiler ., wantnit changed for combi I want new piping change from 15 mm for flow and return , and 8mm to rads. to 22x15 boiler will stay where...

so is this just as simple as securing pipes back In , check circuit board is dry, filling up and see if any leaks then try.fire up?