Recent content by GARYMCC1

Yeah the panel is in the backroom out of view. Will change battery and update you.

There's no prizes for guessing I'm not to clued up. Lol I'm a lift engineer by trade so electronics are foreign to me but not knowing much about the circuitry on alarm systems slows me down to a crawl. I hate admitting defeat but fear you may be right on this occasion. I do however have a hefty...

Hi there, Yes it was a FULL reset as all codes also defaulted back to Factory. Im not sure what you mean by "pull the lot" can you explain? Are you saying I can remove the tamper circuit altogether? wouldnt this allow someone to just kill the outside bell box and get in without system...

Hi I never ststed the system was not used I said there were no codes. The building was liquidated and previous owner did not supply codes. Is there a simple way to test the tampers via the board or do I need to bell out the wires between each pir & bell box?

Hi I have just purchased a building with this system installed and had no codes etc. I did a full NVM and set it up again its a simple system with just 2 PIR's as its an open plan cafe. My problem is this. I arm the system and right away I get a "Tamper" alert and the internal and...