Recent content by Gavona

John, you were correct. I had visually inspected but just dismantling and re-assembling seems to have sorted it so it must have been a dodgy connection. In summary the advice here that I found helpful was: 1. After draining the machine fully turn it upside down 2. Brushes can then be...

This is a really helpful thread - thank you to those who have contributed to it. I replaced brushes, initially had an open circuit on 4/5. Tapped the component and it did solve that problem. However on re-assembling the motor and fitting new fuses I have an open circuit on 2/3! This...