Hi just to let people know the central heating temp controller on front panel plastic spindle had snapped. So although it still turned was not cotrolling temperature.
Yes there is issue with prv sticking open so have to top up system every 4 ir 5 days that is being replaced today but not sure that would affect CH temp.
Hi i have a Ideal logic plus 24 boiler. 5 rads on system all warm but not hot. Temp on boiler set to max. Flow and return pipes feel warm but not hot. What would be likely causes
Cheers George
Hi Richard
thanks again for your time one very important thing I forgot to mention this air locking only happens when shower has not been used, ie it never happens when shower is in use so I suppose this rules out the surrey flange/essex flange issue/overdrawing supply issue. Yes I will try...
Hi Richard
Yes shower feeds come up from pump about 14 inches go across a couple of feet then drop down to shower mixer. I know this is not ideal but outlet has to come up then back down to mixer.
cheers george
Thanks John
So to prove your point if I was to open a hot tap when pump is airlocking I shouldn't be getting water out of that tap as water level in cylinder will be below outlet.
cheers George
hi burner man
thanks for reply how can air be drawn down expansion - the draw off on surrey flange goes down into cyinder by about 6 inches whereas draw off for taps etc comes from top of cylinder if you see what i mean. Thanks in advance George
Hi All
I live in a bungalow with hot water cylinder in loft and cold tank mounted approx 40cm above top of cylinder. I have a twin impellor 2 bar pump mounted at base of cylinder, hot feed is from surrey flange mounted on top of cylinder, cold feed straight from cold tank. All feed pipes are...