I have a worcester Bosch 26 32 oil combi boiler and have been operating it for some time just on a timer for CH (hot water is set to on demand).
I have now taken the plunge and bought a Honeywell cmt927 Rf Chromotherm wireless thermostat.
I have located the linkage wire that needs to be...
I have just fitted the 2 base units that fit into the corner of my kitchen. There is a problem with the corner walls not being at right angles.
This means that the corner worktops will butt up together at an angle which may look a little odd.
I could plane the back of the carcass in the...
I have a number of pine planks spanning a room in my house. The planks will be exposed and have a rough finish. I am thinking of darkening them to a light oak type of colour and am wondering what to use. The cost of interior stain is horrendous and I have a very large area of wood to stain...
I am laying engineered wooden flooring and have just reached a section of the room where there is recessed opening teminating with a UPVC external french door. The boards run at right angles to the door so their short edge butts up to it. The problem that I have is that there is not a lot of...
I have a large drive covered in gravel that I want to concrete over. Beneath the thin layer of gravel is a layer of asphalt followed by brick and finally earth. The top layer is about a foot thick before getting to clay/earth.
The question I need answering is... can I concrete straight on top...