Thats not what I'm experiencing though. I armed the system and deliberately walked into the zone to set the Pir off. Worked fine, reset the system and tried to re-arm again to check another pir (I did not have external siren connected so wasn't worried about annoying neighbours). However the...
I didn't see that M8 but I'll go and have another read :wink: So if it does indead work this way and someone was to inadvertantly activate one of the Pirs, they would need to wait 15min before they can arm the system again or omit it? Or maybe it is removed from the system during arming? I'll...
Choosing the "Elite 48" version in wintex works perfectly with the 48-W although it will show 8 wired zones instead of only 4 zones, ignore 5 - 8.
John
The system is working perfectly apart from this and now I have a 2nd Pir acting the same way :x
I have armed the system over the last two nights with the Pirs omitted and it has worked perfectly with the Contact-W's, wired Pirs and the smoke detectors tested and working 24hours as expected...
Yes they are showing alarm and flashing red, all other bars show green. The contacts clear right away but not the Pirs. I've not had a chance to look more into it yet.
john
Me again :lol:
I've got the replacement 48-w installed now and all devices have been learnt without issue this time 8)
I'm working through the programming and I have it setup as I want it I think, but I'm having issues with the wireless Pirs.
I can walk test all the wireless...
You are correct M8, checked my original order description states newer model and 4 wired zones. Maybe it was a genuine oversight but I need the wired zones for my smoke detectors so going to have to insist on like for like replacement panel.
John
Just received my replacement panel but although it states it is a 48-W I think I have been supplied with a V1 or an export model, it does not have 4 wired zones which I require. Also it is the open power supply not the fully enclosed supply which was in my last panel.
I'm going to get in...
No problem Jibbeh, I have spoken with Paul from Texecom and he is as stumped about this as we are.
He is going to look into it more at the office tomorrow and get back to me.
I'm hoping I don't need to return the panel and it can be sorted without removing the damn thing :D
I'll post...
Well I have defaulted the panel several times now and it point blank refuses to accept ANY of my devices now as well.
I have informed supplier and await a returns confirmation to have have the panel replaced. There is nothing more I can do and I've spent hours this morning trying over and...
Ok so you do it yourself or get someone you know to do it.
I did my own several years ago and not a problem with it since.
What's the worst that can happen - they come out to fix a fault and find you did it yourself and they charge you the fee to fix it.
Then of course you could...
All 8 Ricochet sensors/contacts are now re-installed and working perfectly but I have come up against a brick wall trying to get the key fobs learnt again.
Users > yes > omit > no, countdown begins and I activate a fob a few seconds later I get single beep and back to the screen saying FREE...
Hi Jibbeh,
No faults logged and no chimes on either.
Anyway I decided to start with a fresh canves and defaulted the panel thinking anything I had done to cause the problem would be cleared.
Well now I find the panel will not learn any detectors. Learning as for the v2 panel thorough...