I have to say before this problem when I set alarm it was a bleep bleep noise then when door was shut it was then continuous noise for a bit then it’s armed now when I set it I just get continuous noise thanks
When red and black and blue and yellow are all twisted together I get — when blue and yellow or apart I get C1 and when black and red are apart I get T1 thanks
Ok I have now put the blue and yellow wires on the silver screws and the red and black are now twisted together and on one brass screw I set the alarm waited for it to arm and when I open door the contact does not work the internal siren only goes off when first sensor picks me up then I disarm...
Ok so far come out of E mode with door closed alarm unset when I open front door alarm goes of with T1 displays after I enter my code to cancel alarm I will now do the rest of the checks you have suggested thanks
No sorry I have 1 door front door one set of contacts only.I have tried the one set of contacts in both combinations using red and black and blue and yellow I have now put it back to its original colours which are red and black so it’s just one set of contacts only that I have thanks
I don’t know if I am missing something here maybe I am bloody thick I have now tried door contact this way round and it don’t work so the other way has got to be right cos that’s how it originally was I have also tested the new contact for continuity to make sure it works which it does god it’s...
Also on programme zone 01 which is FE after keypad displays FE it then flashes 0A I don’t think I have any exit and entry times programmed but don’t know how to do this