Recent content by GMan51

Finally I got a pic... any ideas if a Hive can be wired easily to this?

Very kind of you to reply so promptly. I will take a pic of the wiring. Thanks.

Hello, I've a Vaillant boiler with an onboard time clock. Also fed through the wall from the boiler is a thermostat (pic beside the dimmer switch). Can the wiring of this thermostat be used for the Hive if I remove it? Or does the wiring need to come from somewhere else? I have fitted a...

Did you get this sorted? I have the same set up? Thanks.

I'm pleased to report that the re wiring was very simple and it all works brilliantly! Thanks again for your help.

One final question.. the boiler manufacturer has said that a wifi heating unit (such as Hive) can only be installed on the boiler if it is voltage free compatible. Is the hive (heat only) voltage free? Thanks again.

Stem, thank-you very much for your comprehensive answer! You are correct in saying that my current set up does not have a thermostat attached so the wiring should be as you indicate. Many thanks again. Let's now hope that the Hive device works with the boiler that I have and there aren't any...

Hello everyone, I aim to replace the the st9100c with the Hive active heat single channel (no water). Tomorrow I will look at the wiring on the existing st9100c - any ideas what I should expect and do you think it should be a simple direct swap? N, L, 1, 2, 3, 4? blue, brown.. what colours...

All worked perfectly, took 10 mins. Thank you!!

Thank you very much. I'm not why that live wire is earth colour, though I presumed it wasn't actually an earth. My programmer has a wireless thermostat which I've located in a different room, so no wires to worry about then I presume. It will be redundant. I'll give that wiring a go later...

Thank you very much for your response. I've uploaded a few pics showing current programmer (honeywell), wiring in current programmer, and pic of boiler and tank. Hopefully these will help. My new hive device appears to require 6 wires, but my current honeywell programmer only has 4 wires going...

When installing the new unit, is it as simple as replacing the old unit with the new unit and rewiring? My old heating/hot water, wired, Honeywell programmer is located in a cupboard, in a different location from the boiler.

I've no idea what you all mean, but the appliance was not switched on.

Yes, I will. Thank-you for being decent about my stupidly John. I will take all your comments on board.