Recent content by goldeagle

I'm not sure how much of that is sarcasm :LOL: I've got a fall of 1 in 60 over the length which I assumed was ok. I see what you mean about not going with the flow, but I was a bit limited with options - the drain runs under a 1930s extension after that gully so couldn't really go anywhere...

My garage roof has always just drained directly on to the ground through the downpipe, it has never been connected to any drain or soakaway. As I'm getting a new driveway done in a few weeks I decided to connect it up to the existing rainwater drain. There is a gully connected to the original...

Definitely leads to sewer...it is only 2 meters from my inspection chamber, so can see the water start flowing as soon as I pour it down the pipe. No other properties going through my inspection chamber. Removed the pipe and closed it out now!

I'm building some new steps outside to the back door as the ground level is about 50cm lower than the door threshold. Steps being built out of concrete blocks and finished off with sandstone paving to tie in with the patio. I wasn't sure what is best to infill the blockwork with - either...

Attached a photo, as you can see the drain is over a foot from either wall. Poured some water down it, a big bogged up with mud at that entry point but did see some water flowing in the inspection chamber so it is connected up to the main drain. Guess that means it must have been either for...

Possibly, but no indication of any downpipe having been present at any point near it, and it would be an odd place to take rain from guttering at that location (as well as being over a foot away from any wall)

Doing a bit of digging close to the house (built in 1910) ready for building some patio steps to the back door and came across a small diameter open clay pipe in the ground. The internal diameter is about 2.5 inches. I'm not sure where it runs and assume it is no longer functional as there is...

Been out cutting some slabs today so thought I'd report back... Definitely seems that the blade direction was the issue...took off the dust guard and rotated the grinder, and it now cuts through slabs much easier, with the blade pulling the tool forwards into the material as it should do, so...

Makita DGA513Z 18V Li-Ion LXT Brushless 125mm Angle Grinder No, not left handed. The problem is that dust shroud only lets you fit it to the grinder one way... yep, the dust hood will only fit to the grinder one way, and that is with the blade rotating upwards, presumably so that dust...

hmm well that vid is what I am doing as in moving the tool away from my body as I cut. The only thing I'm not clear on is blade rotation, looks like in that pic blade is rotating clockwise down into the slab, whilst for me it would look anti-clockwise. Hopefully to be a bit clearer, the setup I...

Ah right it sounds like that may be what I am doing wrong then and probably why the blades are getting knackered! So just to be clear I should be cutting like this then, pulling the tool towards me:

Diagram below is what I am currently doing...blade rotating upwards, pushing the tool away from me is that right?

yeah one of the Bosch discs I've used was classed as a turbo disc. I am starting to think it may be blade direction in relation to the slab, I was fixed with the blade direction due to the bust shroud only fitting on one way. Will try it in the morning

maybe a stupid question, but what direction should the blade be turning when cutting into the paving (if that makes sense) - should it be rotating downwards as you cut forwards, or rotating upwards? Or does it not matter?

as far as I know, yes...the label is facing out and on the blades that have a direction arrow it's in the same direction shown on the grinder