Recent content by goody974

Sussed it, the boiler above the programers needed resetting... once I did that it worked. Yes stats now linked brown and black/brown. Thank you so much for your helpCBW I owe you a beer

Should I be removing the link to common in the single zone receiver with this setup?

Not sure it's made any difference, the boiler above the programmers hasn't done anything despite the green lights for CH being lit on the receivers

Ah ok, should any of them be linked together then?

It shows as an earth wire going in to the single zone terminal but its what was previously wired to terminal 6 in the old programmer. I have brown tape around it

Yeah understood, i was just trying to tap in to any existing knowledge. Attached is the picture of the 2 back plates. I have terminated all the wires in the previous stats boxes.

Can I jump on this thread? I've followed the wiring above and removed the ESI programmer which had 6 terminals, instead using 2 hive backplates with the above wiring. Everything looks like it's working, however the heating for either zone never comes on. Hot water is working fine. Is there...