Recent content by grahamrex

Yeah, it is notoriously poor around here. That being said, I only get piping hot water at a trickle, so even more reason for concern. Sounds like there isn't an easy fix or much to try from a diy point of view?

I think that equates to 8lpm? And yes, mains cold. Hot water is the same tho.

Hi All. Hoping there are some experts out there that can help me again. Trying to keep this old boiler alive and kicking. Don't have high hopes for this question, but folks were super helpful last time. I have my hot water dial on the boiler turned up to the max. But the water only gets hot at...

Can I get a thermostat that is integrated? Any suggestions? Thanks

[Updated] @CBW @stem @kidgreen61 I took off the outside panel of the R6660D and then turned boiler on and off. And it started up fine and is now status '0'. Which is good news. If I reconnect the relay, it flips to 'C' again (note the room thermostat is set to Off). So good news is I can now...

This is a new problem. Heating has been working fine for past two years (that's how long I have lived here) and assuming longer. When I press the button on the relay I do get a green light, but it doesn't change anything on the boiler. I can turn the boiler off manually, but after booting up...

Not sure how to do that. But will open it up and have a look

I don't believe it has either

Hi @stem, thanks for the reply! I think I have an older receiver. See photo below. Google suggests this is an R6660D model. There are no lights on the receiver. Do you think this means the fault is in the boiler? That would make sense given the room thermostat has no impact

Hi. Hoping there are some experts out there that can help me. Trying to keep this old boiler alive and kicking. Woke up this morning to find the central heating running flat out. The boiler is showing status 'C', which is consistent with the CH running. I have tried the following: - Resetting...