I have an external submersible pump sitting in a 460mm dia chamber. The chamber has a standard cover which I remove whenever we flood and I manually drain water into an aco drain. I am looking for a permanent way of installing the pump
Alongside the inspection chamber is a 110mm sewer line. Can...
The boiler is not connected to the cylinder currently.
The cylinder does have a stat as the attached image shows but this is not connected to the boiler.
The boiler currently has a 230v flex cable and no other electrical connections or wires.
Both DHW and UFH are heated by the cylinder so does that make it a thermal store?
I have flow and return for the boiler, flow and return for DWH and obviously hot water draw and cold water inlet.
I had the cylinder installed in 2007 and am replacing as the immersion element has been weeping...
Apologies for the silly questions in advance.
I have a vaillant 630 plus system boiler tied to a 300l Telford cylinder.
The entire house is heated by UFH with manifolds on each of the 4 floors and each room having a thermostat.
The heating and hot water go through the cylinder which is heated...
Any recommendations for a 300l tin coil indirect unvented cylinder?
I have been quoted for a UK Cylinders model but there doesn't seem to be any information about quality. My installer recommended because the heat loss is quite a bit lower than Joule models.
I have looked at the OSO DTC 300l...
Hello! I have a new Vaillant boiler being installed and will install a new cylinder at the same time. Our installer is recommending a UK Cylinders ProLite Air twin coil solar indirect unvented cylinder 300ltr.
According to specs the standing heat loss is 1.80 kWh/24h which seems pretty decent...
Can anyone tell me what impact running a circulation pump with a larger diameter bore would have?
Currently running an old grundfos 15-6 on 22mm with 1 1/2 threads but looking at a lowara ecocirc 25-6.