Recent content by guymad

Been wiring up my garage with a ring main and 3 electric header points The ring main is fine however when I test the heater points I get a 115v reading from the disconnect live from the fuse board and the neutral- the other end is open and only connected to a terminal strip (first fix stage...

I thought you need clamps to pull the joints in tight and then nail?

Need some advise. I am building a games room in what was a garage and need to raise the floor by 100mm + floor boards. I want to use 18mm solid oak floor board with T&G on all 4 sides and secret nail to the joists with king span insulation in the 100mm space between the joists. Questions are ...

I have cleaned it again and double checked the spark unit and all is fine ( good spark when trigger is pulled and micro switch is pushed down). I have purchased a new paslode gas with date out to dec 2012 and now tested the unit- cycles perfectly but does not fire - now really stuck! help!!!

Hi I have a Paslode 900420 (LM350) nailer which has been perfect for ages and never failed but thought I would do a service - took it apart as per instructions - cleaned it . degreased it, oiled it with paslode oil, replaced the 2 O rings. Put back together. Tried it and did not fire. When I...