Recent content by hayabusa1300

where can i get the motor from is it 12 volts or 240 volts

thanks heating has been working ok as is so i might not bother with a motor just run it as is thanks

Hi having problems with it heating stopped water was working so i manualy moved arm and heating worked for weeks has stopped again i managed to get the cover off with out breaking it or swearing cause i thought was going be a b"""" to do i noticed the motor on the valve to wires to it orange...

hi have acl lifestyle divert valve faulty if i manualy move selector /valve heating works also water i have disconnected power to valve and set in position that heating works great and hot water ok ish runnin like this could it cause any damage i also seen link saying you can change motor on...

i found what think is divert valve or acl as you mentioned has black lever under it hanging down loose if i push it up into valve and push i can fee like valve turning if i carry on all way turning it comes to a stop heating fires up works fine untill turn off and have d o same again when get...

hi i have same problem i go under neath and theres a lack lever hanging down i pish it up and move valve manualy heating then works so u can get motor seperate

hi found valve you was on about was black lever hanging down loose so i pushed it up and then forward could feel like a gate or valve type operation like was opening and i fired heating up light and has stayed light heating working tried water and water seems ok will turn off in while and try...

i see red tank vessell at left hand side at back see white type tank side of that i see is it gas valve i will check tomz wit htorch see if can see divert valve thanks

divert valve ?????????????/ if you could give clue where it is and what looks like i have looked under neath seems big brass collection of valves one with red handle gather that over flow as i found out when turned it and water went out side any plumbers in chorley area ave quick look dont want...

nope heating on standby , not set on demand and pump kicks in but doesnt try ignite yet hot water side works fine

other thing just noticed when it is turned off after while it trys well seems to start pumping but doesnt try ignite that is with out it turned on via control in the off position :(

going ask stupid ? where is it and how do i check it i am a motor mechanic but with your help sure i can sort problem out if water pressure was too high would that cause this problem thanks for help

hi seen valve on pipe work with 2 red wires gather that does flow i toke wires off and tryed run it did same cuts out yet hot water side works perfect

yes trys to and does same thing where would flow switch be located i gather its on water pipe and has 2 wires connected to it 2 red wires

hi boiler if i put on all time fires up pumps runs then gas ignites runs for about 13 seconds then gas goes off pump is still running hot water no problems with nice and hot and gas ok its just central heating side of it not working gauge shows 2 bar water pressure reset button never needed...