Thanks for that Jason, the one with wedges is just what I had in mind although I might make the joint slightly wider. Good links and tips, thanks very much.
Thanks for the tips wikerman! I'm not thinking of selling anything quite yet although I really enjoyed finishing the wood for the hifi...
Jason,
No it wasn't me although I just read that thread as well to see if it was for the same design. I didn't really want to use MDF, the Ash i got was unsawed at the front edge so I have the bark at the front. Looks a bit better than MDF I think :D
Realise my pic didn't come out quite...
Cheers Jason,
I'm actually back in West Wales now after a couple of weeks with my folks in Bath but I'll check that place out when I'm back next.
Thanks,
Tom
Hi Wickerman. Well my first foray into anything to do with wood was when I made a hifi stand...see link below. I'm sure you lot will laugh at this as all I needed to do was drill the holes and do some sanding :roll: I didn't use MDF but got hold of a lovely bit of thick Ash that I sanded and...
Nice one Jason....thats a good site added to the favourites! Looks like my bird table is going to be a work of art :lol:
Still looking for that woodwork bible book...anyone got a link for amazon?
Hi all,
Anyone got any sites that are good for woodwork knowledge. I'm looking at making some bits of furniture and am interested in joins and finishing mainly but a general infomation site with basic intructions and illustrations would be good.
Also...whats the best woodworking bible out...
Thanks noflame....no it doesn't smoke at all really.
Guess a filter change might be a good start...I was thinking it could be something to do with the fuel filter, or maybe fuel pump.
Hi All,
My first post as I've got a problem with a car I've just bought. Its a 1.7 astra merit diesel K Reg with the vauxhall engine.
I only bought it yesterday after a lengthy test drive but on my way home up a steep hill in third the engine seemed to lose power and the revs died for a few...