Recent content by hooper

  1. H

    Problem with newly fitted diaphragm...

    update....i've drained the boiler, had the diaphragm out and thried the best i could to clean the inlet, and also had the pump off and given it a bit of a clean. Still not working. So until i can get an engineer out (i'm at a loss as what to do next), ive wrapped a tiny bit of insulation tape...
  2. H

    Problem with newly fitted diaphragm...

    will drain it down in a bit and have a better look at the pump. I've had a look through the service manual and there is no mention of a DHW diaphragm. That may be on a different model (does the C24 have a magnetic assembly for dhw?). The link to the manual is here
  3. H

    Problem with newly fitted diaphragm...

    there are 4 dip switches on one of the pcb's. Flicking #1 to OFF then ON again puts it in service mode and from the way the 3 led's light up, you get your fault. email sent :)
  4. H

    Problem with newly fitted diaphragm...

    a blockage looks likely... i have put the boiler into service mode and turned on the hot tap, and when it tripped out it was showing the following error; Faulty primary circuit (no water or absence of flow). The pump seems to be working ok, so apart from checking the diaphragm inlet, can...
  5. H

    Problem with newly fitted diaphragm...

    not sure on that one...he did it while i was at work and i can't get hold of him. Is that something i could do myself ( i ended up checking the diaghram myself)?
  6. H

    Problem with newly fitted diaphragm...

    Definitely not a diaghragm problem! Had a look at the pump, it rotates smoothly and if i get the circuit running its ok. I've realised i made a bit of a mistake in my original post. The pin that is pushed out by the diaghragm only does so when the system is up and running, and not before...
  7. H

    Problem with newly fitted diaphragm...

    thanks.....i thought a new diaphram was just too good to be true :cry: he left the old one which was really stretched and out of shape.
  8. H

    Problem with newly fitted diaphragm...

    I have an Ideal Mini C24 (which i believe is the same as a Biasi M90) and had the diaghram replaced today by a reliable heating engineer. The heating wouldn't come on unless you turned a hot tap on! I was at work when the work was done, but when i got home, the house was nice and warm. When...
  9. H

    A slight twist on a common problem...

    thanks, and as usual i was a barn door off!
  10. H

    A slight twist on a common problem...

    I have an Ideal mini C24 boiler installed and am having a problem with the heating. I have searched and searched about this but have only found info regarding a similar but opposite problem to mine.... The central heating timer will switch on and a noise comes from the boiler, not sure if...
Back
Top