Recent content by hsiboy

sigh... and Part p has added greater weight to the whole debacle. Sadly Part P seems mostly concerned with preventing fires. Again most common source is non electric e.g chip pans and cigs. However it points its fingers at bodged electrics. Stuart.

ban-all-sheds, is that your site? k-zone? well done if it is! Stuart.

PLONK!

i don't think you have at all. The point i was making is that you were busy telling us how it wasn't semantics, but then your argument is 100% semantic. At what point did i say the neutral is not at zero volts with respect to earth/ground ?? Are you being deliberately obtuse? we are...

The current alternates because it was induced by moving a magnetic field close to a coil of wire. A magnet has two poles N & S. if you alternate the poles of a magnet close to a coil of wire, a current will appear at the terminals of the coil that has a relationship with the position of the...

ah sterose, There yah go. couldnt help it could you. :shock: another smart alec comment. You also said earlier correct. it doesnt matter. it will still work. however... is not quite right. so, you dont fully understand what is happening. But if you read what other...

<sharp intake of breath>cost yah :D</sharp intake of breath> Nope. better let them think about it. i have had a good rummage in the past threads on here. and often a good piece of advice is shot down by a caustic remark or comment. This forum is about helping people, not scoring brownie...

I quite like this thread, some good stuff in here. But lets not mess about with the laws of physics ok? Phase line alternates between + and - with respect to neutral and earth. why? (i'm not asking, i want you to think about it) Does the neutral line terminate at the star on the...

Ahem. in brit parlance it is called the neutral wire. earth is earth, neutral is neutral no matter what your earthing system TT IT PME whatever. Stuart.

sorry about the state of this, done in a bit of a rush. its as per your wiring. easier to see it. any probs just ask. Stuart. and follow breezers advice :D

not to mention round pin "lamp" sockets. (and i dont mean 15amp rubbers as used by our theatrical sparks). Stuart.

tandy used to sell them. As far as that circuit of bills goes, its a bit ott. one thyristor an led and a resistor will do. which is whats inside of the tandy ones. of course tandy is rip, but there was a company doing mail order in the uk for tandy products (radio shack in the US). Lat...

probably ~ the two reds cable, one of the reds will be live all the time, and the other will go back to the bulb. The red, yellow and blue cable will go directly to the other switch. go have a look to make sure. You need to see what colour is going into what terminal on the back of the other...

oohhh you forgot scissors!! Stuart :D

ah yes, way off :D I agree, i wrote it all ass backwards. What i meant to write was. Light bulbs are known to cause tripping when they meet their maker, but we usualy put them on the non rcd protected side to prevent plunging the house into darkness when the rcd trips. i have just...