Recent content by Hursty

Thanks for all the help on this guys, but though i don't like giving in my town looks better lit up, so i'm getting one of you people up into my loft to sort it out.

It's a mess mate,it really is like spaghetti,at least 6 different blocks with wires & cut off wires going into them.

Will do.......i'll also make sure he can unravel spaghetti aswell,it's a mess with all those cut off bits off wire & 4 wires going into one little connection. :(

Not to me it doesn't,i'm getting a spark in. I've found a black wire coming from the cylinder stat that has a grey wire that has been cut 1/4 of an inch off coming from the other side of the connector,also the brown wire from the stat goes into one side of a connector & an orange one coming...

I think i'm with you, the OTHER 2 wires will be connected to other wires, the wire from the stat that doesn't have a wire going to it is the one the grey wire goes to. If the spark who did this in the 1st place had used a 10 block connector it would have been easier to follow.

Right you handsome lot i'm nearly done after your advice over the last 2 days,BUT & it's a big BUT this GREY wire coming from my sunvic 3 way motorised valve that has either come lose or is not supposed to go anywhere is a problem. I understand that it goes with the wire on terminal 2 on my...

The big fella off ice road truckers is one of nicest blokes on tv,a big family man & risked his life to put food on the table for a huge family.

Cheers,i was wrong.

The one on the left as you view the pic's a ringer for a guy off Ice Road Truckers.

Funny buggers :) Does the arrow on the pump point towards the hot pipe feed from the boiler. ps. i should have said that the 1st bloody time. :oops:

I've removed my old broken one & am about to fit the new one BUT i cannot remember which way round it goes, A pipe goes from a valve on top of the boiler to the pump & a pipe branches off upwards of of it just before it reaches the pump to a plastic tank, this one is slightly warm,the other...

Cheers i'll give that a go.

If the person that put it in had used a 10 pin block connector that would be perfect kev,BUT whoever did it must have only had smaller ones i'm afraid. I'm a novice at wiring so it's a little tricky to folow,i have a couple of blocks that have no wires going to one side & i'm wondering if trial...

Hello people i have dislodged a GREY wire from my central heating junction box, the wires orange,white,blue from my sunvic 3-port valve spring return mid position motorised valve are all connected but i haven't a clue were the grey one should go or if it's critical. Could some kind soul please...