Recent content by hy288

I'm not sure what you really mean by that? and not sure that sounds practical etc.

Our rear fence line is typical straight from one end to the other. This spans across 3 neighbours, the end neighbours we don't have any issues with access as they each have their own separate fence that backs to ours. However, the middle neighbour is the one that doesn't have a fence and they've...

The estate is a new build with 2 main developers - 90/10 spilt roughly... I believe they move in about 10 years before us. So our side would have been undeveloped. Like you i would expect there to have been a fence from their developer, and perhaps there was....where over the years once our...

I’m aware of this convention but understand this is not always the case. I should add that our neighbours development was built way before ours. I can see that every other neighbour looks to have their own fence on that same line as you look down the rear garden. Yeah fence was erected by the...

Are you able to give me some honest answers to each of those questions? Just looking for a reasonable solution btw i.e. trim back the deck so it not touching and give a gap. At the same time sufficient clearance to allow us to maintain the fence posts along that stretch. Its not as if I'm...

Hi all, Looking for some advice and clarity regarding a boundary and maintenance issue we’ve recently discovered. We live in a new-build property and back onto a neighbouring development Our rear fence was installed as part of the original construction, and we’ve since had written...

Thanks again for your detailed response — really appreciated. Just to share my understanding on the DHW side (with a hot water tank): Evohome manages DHW using the CS92 cylinder sensor and a BDR91 relay to control the zone valve. Evohome doesn’t send a specific DHW temperature setpoint over...

Hi all, I'm planning to install Honeywell Evohome for zoned heating control and want to pair it with a system boiler that supports OpenTherm effectively. However, it seems that even with OT-certified boilers, the real-world compatibility varies — especially in terms of feature support and...

Thanks bro. Will give Vokera a look also... I was concerned that may have been the case i.e. lack of public info on OT feature sets. I'll probably sent out a specific post on EvoHome and OT boiler feedback.....someone must know which are good OT feature set boilers that work well with EvoHome.

I assume when you talk about opentherm functionality it would extend to things like: Flow temperature control (basic modulation) Burner status feedback Flow/return temperature reporting Fault code/status reporting DHW control (where applicable) External weather compensation integration (if...

Thanks! Just also got some feedback from Resido (Honeywell). They told me the same, by accessing the immersion heater panel. They mentioned that the insertion sensor should wedged in between the moulded insulation foam ensuring that the sensor contacts the stainless steel immersion heater boss...

Hi, Anyone using EvoHome controls in S-Plan Plus arrangement with Opentherm? I'm considering the EvoHome setup with a new boiler upgrade (Baxi 800 System 2 boiler?). We have S-Plan Plus - x2 CH zones, x1 HW; with an unvented cylinder - Santon Premier Plus 250L (PP250B). Having investigated...

Thanks for highlighting that. Come to realise that the baxi system version also has a internal expansion vessel. In comparison to my current Potterton Promax setup, where we have an external pump and external vessel for CH (i guess our potterton is a heat only boiler). I assume both external...

I'm certain its not the condensation trap. If the leak is around the connection points on the hex i.e unions....is that still consider scrap? I recall seeing the stains around the hex connection points, and slightly below the manifold area. Like you say, probably just need a someone to have...

Hi, Looking to replace our boiler setup, we have 2 thermostat zones (upstair/downstair) along with a separate unvented hot water system paired with standard programmer. I believe this is in a S-plan arrangement. Currently thinking about a Baxi 800 system boiler which is to replace our old...