Recent content by i5hyp

It was probably my mistake. I assumed he wouldn't be screwing into a newly tiled floor, maybe he would just build a frame and screw against walls and I had forgotten to mention the pipes as assumed he was around when it was being laid. An oversight that I'm hoping doesn't cost me..

So Iv been checking over the last 3 days. We have dropped from around 1.6 to around 1.2 now. Speaking to the installers, they said the drop in the gauge is normal and will fluctuate until you commission the boiler. If there was any damage, damp patches are the most common signs but as Iv tiled...

Thanking you for all your help

So the screws were all taken out and we waited a while and there was nothing coming up through the screw holes or the floor has remained dry so I think it seems to be OK.The only thing puzzling me is the pressure gauge dropping. This system has been in for quite some time so I'm hoping it's just...

We took out the screws to check all the screws and no water or any signs, although I guess it would leak below l presume? My buildup is tile, adhesive, decoupling membrane, pipes in screed. The gauge has dropped from 1.6 to 1.3ish bar and is stable at that. There is no other heating on in the...

I have an uncommissioned wet underfloor heating system in screed. Yesterday the joiner was screwing into the newly tiled floors and may have potentially screwed into a UFH pipe (on the borderline of pipes). The pressure gauge on the UFH manifold was showing around 1.5 bar and dropped to around...