Recent content by i8diy

Well at least you're prepared to have a go at answering the original question, even if you do seem reluctant to accept that there are NO fixings/fittings supplied with the cabinet. It is an Ikea unit. They don't supply fixings. Contrary to the nonsense posted by some on here, hollow wall...

No, the problem is that there are far too many people on this site who are incapable of giving a simple answer to a simple question. If you don't have an answer then don't respond, it's not complicated.

Anyone would think i'd posted the original question in a foreign language. I clearly stated that i had 'encountered a stud partition directly in line with the position i had planned to fit the hollow wall anchor' and yet you are asking me whether i've 'encountered a stud directly behind the...

May i respectfully suggest that if you have difficulty reading the post properly perhaps you shouldn't bother posting a reply. What's the point in giving your 'advice' for free if that advice is totally irrelevant? I specifically asked whether there was any particular screw which would do the...

The anchors aren't the problem. Try reading the original post properly.

...and how does that answer the question?

Brilliant.

Can't use washers either because the cabinet already has it's own adjustable fittings which act like washers. The question i really need to answer is whether a simple screw will be strong enough to support one corner of the wall cabinet if the other corner is supported by a hollow wall...

Countersunk head is no good i'm afraid. The wall cabinet will just slip off.

I'm fitting a corner wall cabinet in the kitchen and have encountered a stud partition directly in line with the position i had planned to fit the hollow wall anchor. Is there any particular screw i could fit directly into the partition? I've looked at self-tapping screws but haven't found...

My Grundfoss central heating pump is hot even when the timer is switched off and the pipes into and out of the pump have long since cooled down. If i run a bath the pump cools down almost immediately. Any ideas?

It's actually an internal vent that i need. That one might well do the job. Many thanks.

What use is that if i need one that's at least 10" x 6"?!

Well pardon me for not being psychic Mr. Sensitive! It might well have been the correct response but without the detail you've just provided it was completely and utterly pointless.

Great. Thanks for that valuable contribution.