Recent content by IgorS

  1. I

    Help! Potterton Combi80 CH fault, DHW OK

    Thanks for the tips, Tony. Well, that fixed diagnostic fee is reasonable enough to me. At the end of the day, you have to keep your thirsty van running and London is everything but not small city. I suppose that on top of that there is servicing fee per hour plus any spare parts (costs). Is...
  2. I

    Help! Potterton Combi80 CH fault, DHW OK

    Cool. Thanks for that. That hissing sound I mentioned above (and it's present also 5-10sec when the system enters idle mode) may suggest that pump is somewhat struggling. It's very hot too. It's "Circulating Pumps" "CP61" CODE: 8104E0106. It's the same pump as previous one (which died year...
  3. I

    Help! Potterton Combi80 CH fault, DHW OK

    Tony, Thanks for that! Fair enough! Eh ?! Because I didn't want to mess up with the electrical affairs! Let alone the electricity + boiler combo itself. Matter of the fact is: After the work was done (10min PCB replacement) and I paid for the service, I was started to get suspicious...
  4. I

    Help! Potterton Combi80 CH fault, DHW OK

    Hey Agile, I really don't have a time or nerves to argue with you. My point was that I had some terrible experience in the past and I need just some guidance if a) If problem is minor and fixable by me (and I'm technically and hardware minded) b) who to call ... even if that includes yellow...
  5. I

    Help! Potterton Combi80 CH fault, DHW OK

    Hey Chris, thx ! Huh, pump was replaced with the brand new one (I hope) approx year ago. Is it possible that it's such low quality pump ?! Now, that "shhhhh" sound I mentioned last a bit (5sec or so) after I switch off the HW tap and boiler returns back to idle state. I'm not quite sure...
  6. I

    Help! Potterton Combi80 CH fault, DHW OK

    Hi, first time poster :) From yesterday, my Potterton Combi80 started to behave strangely. This is the fault explanation from me and I'm no expert in this field: - When DHW is triggered by turning the hot water tap ON, red light on the PCB board goes ON, gas chamber looks & sounds OK...
Back
Top