Recent content by iob

i'd add - also check 'full bore' isolation valves are being fitted to your hot water side - regards

hi all, i'm considering this set-up: dallmer wet room drain running into a 43mm solvent weld pipe that runs to a 50mm 't' (the 43mm pipe is then sat in a 50mm reducer inside the 't') the other side of the curved 't' is a 32mm sink pipe (again in another 50mm reducer) then both run into 50mm...

hi all, i've been asked by a family member if it's possible to place a double panel radiator (900mm w x 600mm h) near a gas meter. the gas meter sits approx 1.2m up the wall (we're in a basement room) so the rad would be placed under the meter. i'm not comfortable doing this, the gas pipes run...