Recent content by JackofallMO1

Hi Bob, yes I will probably get with it and pluck up the courage to get at the baffles. I am sure that I should be able to repair/replace any baffles provided that I can see what they should have been like. I have a couple of new nozzles standing by for use. 1of Delevan W .75 @ 80' (semi solid)...

Hi Terry, FGT?. I do not think I have seen the baffles for years. I replaced the 5 access hatch covers with alloy plate and stainless nuts long ago. Used plumbers flame proof matting as seals. Did a nice job with no leaks/puffs since. I would not like to disturb them unless really necessary but...

Hello to all in the past. I and the boiler are still going strong. Could be some sort of a record? Lots of trouble with old emails and Health hence long time out but I have managed to get back in to forum. Since the last posts I have discovered a product called 'Vermiculite' works a dream in the...

Still soldiering on and keeping my brain working.

Thank you Oilman and Mandate. all good info. Just what i needed. I can confirm that the nozzle is 80 degree @3.78 litres per hour rated. I did not put a pressure gauge on as i could see from the spray and the pump internals that there was low pressure due to wear and tear. (used to oil pumps...

Thanks OILMAN, that's sound advice but i feel that there must be something to enable the correct assembly of the projecting oil spray assembly within the blower passage and the correct location / spacing of the electrodes etc prior to flame analyzing? Some one has to put the thing together in...

I have solved the problem of the noise by fitting new Oil pump but i would like to ensure that all the Set up for the burner etc is correct. Does anyone out there have a Tech Manual that would contain Exploded views and settings for the following??? and if so could supply pics or Photocopies...