Recent content by James3670

That's ideal then, I am new to this forum, and should look around a bit more. A good result in the end.

Thanks JohnD, I am going to stick with the rawl plug and screw method, a friend of mine has done it, and it's stayed up for a few years, so hopefully mine should see my mother out!

I do see what you mean about utilising the existing holes, it's possible I could use them in some way, they had steel wire through them originally, and therefore run in the same direction as the fence, they are small though, about 8mm in diameter, so I would need galvanised wire or similar to...

Both types of post are square section, I was going to drill a hole in the concrete posts at 90 degrees to the existing ones, far enough away not to be a problem (4"). The concrete ones are council type, and in very sound condition thanks for the interest.

I am putting up Willow 'Hurdles' as a 24' fence. There are existing concrete posts that I wish to attach the fence posts to. Any advice or ideas on the best way of fixing the posts to the concrete would be greatly appreciated. I was thinking either sleeved anchors, but wondered if rawl plugs...