Recent content by jase_one

sounds a good bet I guess, but why did it work fine for so long? I'll put a new 15m tap on it tomorrow and eliminate the problem as I know there is loads of pressure in the normal open taps, thanks for the ideas.

I mean the shower is either scolding hot or freezing cold and cannot be set in between to be use, changing the dial does not vary the temp but moves it from one extreme to the other, there is no 'middle' setting that would be useable.

I've had a volt meter running across the inlet power and appears to be constant at all times when hot or cold.

Lights appear fine and shower appears fine, there is no variation in temp if left alone, if the dial is turned up it Red hot, if turned down it goes totally cold, the temps don't change on there ownwithout the dial being moved, but it only works at both extremes of temp.

There is no variation in temp when just left running, it is either hot or cold depending on the temp dial, no variation at all.

the cold supply water is comming from a 'self cutting' 15 mm tap which I have seen to be a problem with drops in pressure on outside taps before, could this be same if the water pressure has dropped a little overall and gone below limit ? would you suggest I change the self cutter for a better...

Just opened shower switch up and reads 50amp / 250v, this info any use to you?, thanks for the fast response.

Trition Ivory 2 is 9.5kw / Gainsborough is 8.5 kw both running from cold supply running to bath taps.

1st Was a triton Ivory 2, now fitted a gainsborough. not sure of power rating on amps but was working fine before

6 month old shower starts running either red hot or stone cold and cannot be set any differently, pressure seems fine,got new shower but have exactly same problem, there is just no \\\'warm\\\' just the extremes. Many thanks f0r any ideas ???