Recent content by jason.bond

Hello again. I pulled the Ignition board today. There are one resistor dry jointed on both ends. I re-soldered them. We shall see if that catches the fault. Thank you for the advice! £1 for kicking it £99 for knowing where it kick it :-) Cheers Jason

Thank you for your advice. Any advice on where to get parts? The online suppliers are using part numbers that do not tally with those in the Service manual. Cheers Jason

Correct it is a Maxin 24e. Fan Venturi - checked and cleaned Dirty main heat exchanger - checked and cleaned fins. Have not looked at internals Air Pressure switch/tubes - Suspect. I wish to replace this Gas Valve - I did reset this as per the manual, and it seems a bit better, but not...

Hello. I have a Vokera 24e Hot water and CH works. Occassionally the hot water goes to lockout when it has been on for some time. Regularly the CH goes to lockout after being on for a while. The Boiler always seems to fire up when you turn on the CH or a hot water tap, unless it is...